Hyundai Grand i10 Owner's Manual page 211

BA RHD 7_PB eng 5.qxd 8/22/2013 3:20 PM Page 11
Starting the diesel engine
To start the diesel engine when the
engine is cold, it has to be pre-heated
before starting the engine and then have
to be warmed up before starting to drive.
1. Make sure the parking brake is
applied.
2. Manual Transaxle - Depress the clutch
pedal fully and shift the transaxle into
Neutral. Keep the clutch pedal and
brake pedal depressed while pressing
the engine start/stop button to the
START position.
Automatic Transaxle - Place the
transaxle shift lever in the P (Park)
position. Depress the brake pedal fully.
You can also start the engine when the
shift lever is in the N (Neutral) position.
3. Press the engine start/stop button
while depressing the brake pedal.
4. Continue depressing the
brake pedal until the illu-
minated glow indicator
goes off. (approximately
W-60
5 seconds)
5. The engine starts running when the
glow indicator goes off.
✽ NOTICE
If the engine start/stop button is pressed
once more while the engine is pre-heat-
ing, the engine may start.
Driving your vehicle
Starting and stopping the engine for tur-
bocharger intercooler
1. Do not race or accelerate the engine
immediately after starting.
If the engine is cold, idle for several
seconds before sufficient lubrication is
ensured in the turbocharger unit.
2. After high speed or extended driving,
requiring a heavy engine load, idle the
engine about 1 minute before turning it
off.
This idle time will allow the turbocharg-
er to cool prior to shutting the engine
off.
CAUTION
Do not turn the engine off immediately
after it has been subjected to heavy
load. Doing so may cause severe
damage to the engine or turbocharger
unit.
7 11