Seagull cassutt 3M Racer Assembly Manual page 7

INSTALLING THE FUSELAGE SERVO.
Required Parts
• Fuselage assembly
Required Tools and Adhesives
•
Drill
•
Drill bits:2mm
• Phillips screwdrive (small)
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Rudder servo .
Elevator servo arm.
www.seagullmodels.com
Throttle servo .
Elevator servo arm.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm as same as picture below:
Loctite secure.
1 PCS.
Elevator servo arm.
Adjustable Servo
connector.
Servo arm.
Rudder servo arm.
Throttle servo arm.
7