Apply The Decals - Seagull cassutt 3M Racer Assembly Manual

2x6mm

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean and
free from oily fingerprints and dust. Position
decal on the model where desired, using the
photos on the box and aid in their location.
2) If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain the
model is clean and free from oily fingerprints
and dust. Position decal on the model where
desired, using the photos on the box and aid
in their location.
INSTALLING THE BATTERY-RECEIVER.
Required Parts
• Fuselage assembly
•
Receiver
•
Receiver battery
Required Tools and Adhesives
•
Phillips screwdrive
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration.
3) Route the antenna in the antenna tube
inside the fuselage and secure it to the bot-
tom of fuselage using a plastic tape.
www.seagullmodels.com
Required Parts
•
•
•
•
•
Required Tools and Adhesives
•
•
•
•
wing set to fuselage .
1) Attach the aluminium tube into fuselage.
2) Insert two wing panels as pictures below.
ATTACHMENT WING-FUSELAGE.
Fuselage assembly
Wing assembly
Wing tube
M4x12mm socket head screw(2)
M4 washer(2)
Phillips screwdrive
30-minute epoxy
Drill bit 3mm
Drill
Locate the items neccesscery to install the
Wing tube.
21