Drain Motor Valve Replacement; Brake Adjustment - Daewoo DWF-7560 series Service Manual

DRAIN MOTOR AND VALVE REPLACEMENT
• Lay the front of the washer on the floor.
• Loosen the adjustment screw and four bolts
mounting the drain motor.
• Take out the wire of drain motor from the bracket.
Wire Bracket
Drain motor

BRAKE ADJUSTMENT

• Loosen the adjustment screw fastening the bracket
and place the adjustment screw to the brake lever
as shown in figure.
• Tighten the adjustment screw completely.
Brake lever Adjustment screw
NOTE:
1. The brake adjustment has been made at the factory, so that it is not to re-adjust. However, in case of insufficient
brake operation, perform the upper procedure.
2. Overtightening of the adjustment bolt will cause poor brake performance.
3. Undertightening of the adjustment bolt will cause continuous bracking and, thereby, cause the problems of the
motor during the spin cycle.
Adjustment
screw
3mm
• Separate the drain motor from the bracket.
• Turn the valve lid by using screw driver as shown in
figure and remove the valve lid from the valve frame.
Valve frame
Screw driver Valve lid Pin Pin
• Loosen the adjustment bolt and turn the adjustment
bolt until the end of the bolt touches to the b rake
lever.
• Tighten the lock nut and apply a small amount of
paint-lock.
Adjustment bolt
Gear mechanism ass'y
Clutch lever
33
Bracket
Adjustment
screw
Valve
packing
Valve lid
Brake lever