How To Clean The Drain Filter - Daewoo DWF-7560 series Service Manual

HOW TO TO CLEAN DRAIN FILTER [Pump]
In this washer machine, the drain filter is equipped at the back side of it.
This drain should be cleaned frequently (every 5 times of use) for its smooth operation.
And this should be cleaned frequently (every 5 times of use) for its smooth operation.
Drain problem could be caused if the drain filter is not cleaned at proper time.
Please keep it clean.
In case you clean the drain filter, please follow the instructions as below.
Remove the
¡
remained water
ƒU Put down the remained water in
the hose. And put a container
under the filter to collect water.
HOSE
CONTAINER
FILTER
Remove the
¢
remained water
ƒU Clean the drain filter removing the
foreign stuffs.
FILTER
CAP
NOTES: During the operation, the "OE" signal means drain error can be displayed on the control panel.
In this case, the main cause of that problem is the blocking of the drain filter.
If you clean the drain filter following above instructions, you could continue the normal operation of the washing
machine to reset the program, please turn the power off and on again.
™
Unscrew the cap
ƒU Turn the cap counter clockwise.
∞
Unscrew the cap
ƒU Put in the filter along the guiding
prominence of the case. Please
note the right position of the filter
adjusting the groove to the guide
rib.
FILTER
CAP
Release the filter
£
assembly
ƒU Pull our the filter assembly off the
case of the main body.
CAP
Release the filter
∞
assembly
ƒU Turn the cap clockwise tightly.
CASE
GUIDE
RIB
SLIT
SLIT
CASE
CAP
19