Toyota Land Cruiser 1996 Owner's Manual page 95

5. With your identification number ap-
pearing on the display, press the "SCAN"
button and hold it in until "SEC" appears
on the display. "SEC" will go off to indicate
the system is set. If invalid buttons have
been used, "Err" will appear on the display
before "SEC" appears. Try again from the
step 3.
Once the system is set, the indicator light
turns on and off with the ignition switch
"OFF" and "SEC" will appear each time
the key is turned to the "ACC" position.
To change the identification number for
some reason, cancel the system (See
"Cancelling the anti-theft system") and
set it again with a new number.
WWW.MANUALS.WS
The system will be activated if the electri-
cal power source is disconnected from the
radio unit. When the system is activated,
the audio system cannot be turned on
even after the power supply resumes and
"SEC" will appear on the display. If this
happens, such as when the battery is dis-
charged, see "If the anti-theft system is
activated".
WWW.MANUALS.WS
Cancelling the anti-theft system
1. Follow the steps 1 to 4 described in
"Setting the anti-theft system".
2. With your identification number ap-
pearing on the display, press the "SCAN"
button and hold it in until "- - -" appears
on the display. "- - -" will go off to indicate
the system is cancelled. If invalid buttons
have been used, "Err" will appear on the
display and "SEC" appears. Try again
from step 3 in "Setting the anti-theft sys-
tem".
93