Toyota Land Cruiser 1996 Owner's Manual page 75

(e) Adjusting the sound balance
To balance the sound between the right
and left speakers, push the "BAL FADE"
knob (if pushed in) and turn it.
To balance the sound between the front
and rear speakers, push the "BAL FADE"
knob (if pushed in), pull it fully out and
turn it.
(f) Listening to the cassette tape
1. Put the cassette into the slot, with the
tape side to the right and lightly push it in.
The tape player will grab the cassette and
slide it into place to play it. If the radio is
on when inserting the cassette, the radio
will automatically turn off.
If the cassette is already in the slot, push
the "TAPE" button.
At this time, "PLAY" will appear on the dis-
play.
The tape player can also be turned on by
pushing the "PWR.VOL" knob if the tape
player was playing when the system was
turned off by pushing the knob.
2. If using a tape recorded with DolbyD
NR*, push the button marked with the
double-D symbol. The display will indi-
cate that the Dolby noise reduction sys-
tem is on.
WWW.MANUALS.WS
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound reproduc-
tion, play your tapes with the DolbyD NR*
on or off according to the mode used for
recording the tape.
To play a tape recorded without DolbyD
NR*, push the button again to turn off the
DolbyD NR*.
*: Dolby noise reduction manufactured under license from Dolby Lab-
oratories Licensing Corporation. "DOLBY" and the double-D symbol
are trademarks of Dolby Laboratories Licensing Corporation.
3. Turn the "PWR.VOL" knob to adjust
the volume.
4. Select your program. (See "(g) Select-
ing a program".)
5. Adjust the tone and sound balance.
(See "(d) Adjusting the tone" and "(e) Ad-
justing the sound balance".)
6. To turn the player off, push the
"PWR.VOL" knob.
7. To eject the cassette, push the
"EJECT" button. As this is done, the play-
er will turn off. If the radio was on when the
cassette tape was inserted, it will auto-
matically turn on again.
You can eject the cassette only once after
the system is turned off.
WWW.MANUALS.WS
(g) Selecting a program
1. Push the "PROG" button to select a
side to play. The tape operation indicator
display shows you which side is being
played.
The player will automatically reverse di-
rections at the end of the tape to play the
other side.
2. Push the "REW FF (TUNE SEEK)"
button on either side to fast forward or re-
wind the tape. At this time, "FF" or "REW"
will appear on the display. To stop the tape
while it is fast forwarding, push "FF" or
"TAPE"; to stop the tape while it is rewind-
ing, push "REW" or "TAPE". The tape will
immediately begin to play.
73