Toyota 2007 Highlander User Manual page 389

Side chain
Cross chain
TIRE CHAIN SELECTION
Use the tire chains of correct size.
Use the following type chains.
mm (in.)
A Diameter of side chain
B Width of side chain 10 (0.39)
C Length of side chain 30 (1.18)
D Diameter of cross chain
E Width of cross chain 14 (0.55)
F Length of cross chain 25 (0.98)
Regulations regarding the use of tire
chains vary according to location or
type of road, so always check them
before installing chains.
NOTICE
If the wrong combination of tire and
chain is used, the chains could dam-
age the vehicle body.
CHAIN INSTALLATION
Install the chains on the front tires as
tightly as possible. Do not use tire
chains on the rear
chains after driving
(1/4—1/2 mile).
When installing chains on your tires, care-
fully follow the instructions of the chain
manufacturer.
If wheel covers are used, they will be
scratched by the chain band, so remove
the covers before putting on the chains.
3 (0.12)
4 (0.16)
'07 HIGHLANDER_U (L/O 0608)
D
Do not exceed 50 km/h (30 mph) or
the chain
mended speed limit, whichever is
lower.
D
Drive carefully
holes, and sharp turns, which may
cause the vehicle to bounce.
tires. Retighten
D
Avoid sharp turns or locked−wheel
0.5—1.0 km
braking, as use of chains may ad-
versely affect vehicle handling.
D
When driving with chains installed,
be sure to drive carefully. Slow
down before
avoid losing control of the vehicle.
Otherwise an accident may occur.
2007 HIGHLANDER from July '06 Prod. (OM48682U)
CAUTION
manufacturer's recom-
avoiding bumps,
entering curves to
389