Toyota 2007 Highlander User Manual page 119

High−Low beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight high beam indicator light
(blue light) on the instrument panel will
tell you that the high beams are on.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
with the knob turned to "OFF".
'07 HIGHLANDER_U (L/O 0608)
TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
The key must be in the "ON" position.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See "Replacing light
bulbs" on page 396 in Section 7−3.
Headlights and turn signals
(without automatic light
control system)
HEADLIGHTS
To turn on the following lights: Twist
the headlight/turn signal lever knob.
Position 1—Parking, tail,
side marker and instrument panel lights
Position 2—Headlights and
above
The lights automatically turn off when the
driver's door is opened with the ignition
turned off. To turn them on again, turn the
key to the "ON" position or actuate the
headlight switch. If you are going to park
for over one week, make sure the head-
light switch is off.
2007 HIGHLANDER from July '06 Prod. (OM48682U)
license plate,
all of the
119