Regency Horizon HZ42STE-NG Owners & Installation Manual page 39

9) Install the ground wire to the ground lug just behind and to the left of the
valve on the HZ42E and to the right of the valve on the HZ42STE.
HZ42E
10) Install 4 - AA batteries into the receiver, ensure correct polarity.
11) Plug receiver wires into the back of the receiver and bundle wires
with the wire clip as shown below.
12) Connect GTM motor wire from the stepper motor to the wire connector
from the receiver wire harness.
13) Program Receiver and transmitter (refer to manual)
Note: DO NOT USE 4 AA batteries in the battery pack on the tray; the
DFBC is now powered by the receiver batteries in the wall.
Regency Horizon™ HZ42STE Gas Fireplace
14) Install the receiver in the wall or if that is not possible - to the tray.
HZ42STE
15) HZ42E Only: Manoeuvre the tray into the base of the unit using the
HZ42STE Only: Manoeuvre the tray into the two L brackets on the backside
HZ42E Only:
16) Install the heat shield over the tray by slotting tabs into slots located the
HZ42E
stops to guide how far back the tray sits.
of the front wall of the unit base.
HZ42E
HZ42STE
location shown below.
INSTALLATION
HZ42STE
39