Connecting The Speakers; Connecting An External Component - JVC CA-MD9R Instructions Manual

CAUTION: Make all connections before plugging the unit into an AC power outlet.

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the
CA-MD9R and the other end to the speaker.
1. Open the terminals and insert the speaker wires firmly (be sure to remove the insulation at the
2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–)
Right speaker
IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on
the back panel.
CAUTION: If a TV is installed near the speakers, the picture on the TV may be distorted. If this
happens, place the speakers away from the TV.

Connecting an External Component

VCR (or another component)
(Refer to instructions for speakers as well.)
ends of each wire first), then close the terminals.
terminals marked RIGHT on the CA-MD9R.
Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–)
terminals marked LEFT on the CA-MD9R.
You can connect another component to the AUX jacks, and reproduce the sound of the
component through the CA-MD9R.
Note: When you connect a VCR to the CA-MD9R, connect the VCR and the TV directly using
the video cords to watch a video tape or record a TV program.
Main Unit
SPEAKERS
RIGHT LEFT
To the audio output jacks
Left speaker
AUX
LEFT
RIGHT
5