Kärcher K 2.56 M Operator's Manual
Hide thumbs Also See for K 2.56 M:

Advertisement

K 2.56 M
5.963-407.0
(06/09)

Advertisement

Table of Contents
loading

Summary of Contents for Kärcher K 2.56 M

  • Page 1 K 2.56 M 5.963-407.0 (06/09)
  • Page 2: Table Of Contents

    Max. Pressure 1600 PSI Max. Water Flow 1.25 GPM Customer Support Amp draw 13 AMPS Mexico Voltage 120 V Call: 01-800-024-13-13 for help or visit Part No. 1.601-542.0 our website: www.karcher.com.mx Serial no. For household use only! English...
  • Page 3: Model Overview

    MODEL OVERVIEW 1 High pressure outlet 11 Water inlet with garden hose 2 Detergent suction tube with filter connector 3 ON/OFF switch 12 Wheels 4 Hose/Cord Hook 13 Trigger gun 5 Retrectable transport handle 14 Trigger gun safety lock 6 Handle 15 High pressure hose 7 Transport handle lock 16 Locking slide for high pressure hose...
  • Page 4: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS physical injuries to the operator and WARNING When using this product basic precau- irreversible damage to the machine. tions should always be followed, includ- CAUTION ing the following: Gun Kicks Back – Hold with both Read all the instructions before us- hands.
  • Page 5 OPERATE THIS PUMP WITH COM- WATER SUPPLY PONENTS RATED LESS THAN 1600 (Cold Water Only) PSI WORKING PRESSURE (IN- CLUDING BUT NOT LIMITED TO CAUTION SPRAY GUNS, HOSE AND HOSE When connecting the water inlet to the CONNECTIONS). water supply mains, local regulations of BEFORE SERVICING, CLEANING OR your water company must be observed.
  • Page 6: Assembly Instructions

    ASSEMBLY INSTRUCTIONS STEP 2: Required tools A Pull out the locking slide of the trig- Screwdriver, small size (not supplied) ger gun handle. for connecting high pressure hose and B Insert the small end of the high pres- trigger gun. sure hose into place.
  • Page 7 We recommend that you test the GFCI as part of your startup procedure each time you use your pressure washer. To learn how to peform this test on your unit, visit http://www.karcher- residential.com/gfci_test.php for detailed in- structions for your type of GFCI.
  • Page 8: Using The Accessories

    USING THE ACCESSORIES WARNING Dirtblaster® To avoid serious injury never point This nozzle features a 0º pencil jet spray nozzle at yourself, other per- which rotates 360º for maximum dirt sons or animals. cutting action, effectively increasing Always test an inconspicuous area cleaning performance up to 50%.
  • Page 9: Working With Detergents

    WORKING WITH DETERGENTS Detergents can only be applied at For best results see Cleaning Tips low pressure (Min.). for specific information on how to STEP 1: clean different surfaces. Install the Vario Power Spray Wand. Set the spray wand to the low pres- Always Use Kärcher Detergent for ®...
  • Page 10: Taking A Break ..Five Minutes Or More

    TAKING A BREAK ..five minutes or more STEP 1: Release trigger and engage gun safety lock. STEP 2: Turn pressure washer to OFF (0) po- sition. SHUTTING DOWN & CLEAN-UP STEP 1: STEP 5: Turn the switch to OFF (0) position Disconnect the garden hose from and unplug cord from outlet.
  • Page 11: Winterizing And Long-Term Storage

    WINTERIZING AND LONG-TERM STORAGE 1: Disconnect all water connections. CAUTION 2: Turn on the machine for a few Failure to follow the above directions seconds, until the water which had will result in damage to the pump as- remained in the pump exits, turn off sembly and accessories and will void immediately.
  • Page 12: Cleaning Tips

    CLEANING TIPS House Siding CAUTION Before cleaning any surface an in- (with or without detergent). Pre-rinse conspicuous area should be cleaned cleaning surface with fresh water. If us- to test spray pattern and distance for ing detergent, apply to surface at low maximum cleaning results.
  • Page 13 Cars, Boats & Motorcycles Patio & Lawn Furniture (with or without detergent). Pre-rinse (with or without detergent). Pre-rinse vehicle with fresh water. If using deter- furniture and surrounding area with gent, apply to surface at low pressure. fresh water. If using detergent, apply to For best results, clean one side of vehi- surface at low pressure.
  • Page 14: Troubleshooting

    Troubleshooting CAUTION Disconnect the machine from the power source before making any repair. Symptom Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) (O) position. position Tripped GFCI plug. Press “RESET” button on GFCI plug.
  • Page 15 Water seals are damaged or Call Customer Support permissible). worn. Oil Drip. Oil seals are damaged or Call Customer Support worn. USA / Canada: If you encounter any additional difficul- ties not listed, please visit our website. www.karcherresidential.com Mexico: www.karcher.com.mx English...

Table of Contents