Daikin VKM50GMV1 Installation Manual
Daikin VKM50GMV1 Installation Manual

Daikin VKM50GMV1 Installation Manual

Total heat exchanger hrv ( heat reclaim ventilation) with dx coil

Advertisement

Total Heat Exchanger
HRV (Heat Reclaim Ventilation) -with DX Coil-
MODELS
(Ceiling mounted duct type)
With DX coil & Humidifier
VKM50GMV1
VKM80GMV1
VKM100GMV1
HRV;Heat Reclaim Ventilation
Please read this installation manual carefully and install the unit properly to keep it at full capacity for a long time.
Please provide some necessary parts, for example round hoods, air suction/discharge grilles etc., before the installation of the unit.
HRV;Wärmerückgewinnungslüftung
Lesen Sie dieses Installationshandbuch bitte sorgfältig durch, und installieren Sie die Einheit korrekt, so daß sie ihre Leistungsfähigkeit noch lange
Zeit behält.
Einige erforderliche Teile wie z. B. Rundkappen, Luftansaug-/Lufausblasgitter müssen bereits vor der Installation der Einheit vorhanden sein.
HRV;Ventilation avec récupération de chaleur
Veuillez lire attentivement ce Manuel d'installation et installer correctement l'appareil de manière à ce qu'il puisse être utilisé pendant une longue
période de temps sans aucun dérangement.
Veuillez vous procurer certains éléments nécessaires, tels que des capuchons de formes arrondies, des grilles d'aspiration/évacuation d'air.,avant
l'installation de cette unité.
HRV;Ventilación con recuperación de calor
Por favor lea cuidadosamente el manual de instalacion e instale correctamente la unided para que pueda conservar su plena capacidad durante un
largo periodo.
Por favor, antes de proceder a la instalacion de la unidad, proporcione las piezas necesarias, por ejemple tapas redondas, rejillas de aspiracion y de
impulsion de aire, etc.
HRV;Ventilazione per recupero del calore
Leggere attentamente questo mauale ed installare correttamente l'unit in modo da farla funzionare a lungo al massimo delle sue capacita.
Prima dell'installazione, è opportuno disporuno delle partinec-essarie, come ganci arrotondati, griglie di aspirazione/di mandata, ecc.
HRV; Αερισìüò ìε ανÜκτηση θερìüτηταò
ÄιαβÜστε προσεκτικÜ το παρüν εγχειρßδιο εγκατÜστασηò και εγκαταστÞστε σωστÜ τη ìονÜδα για να διατηρÞσετε την πλÞρη απüδοσÞ τηò
για πολý καιρü.
Προìηθεìτεßτε ìερικÜ απαραßτητα εξαρτÞìατα π.χ. κυκλικÜ καλýììατα, εσχÜρεξ αναρρüφησηò/κατÜθλιψηò κ.τ.λ. πριν εγκαταστÞσετε τη
ìονÜδα.
HRV;Hergebruik van warmte
Lees eerst zorgvuldig deze installatiehandleiding en installeer de unit op de juiste manier, zodat deze gedurende lange tijd zijn volledige vermogen
kan leveren.
Zorg dat alle componenten aanwezig zijn, zoals ronde kappen, luchtaan-en afvoerroosters etc. voordat u de unit gaat installeren.
HRV;Ventilação de Recuperação Térmica
Leia atentamente este manual e instale correctamente esta unidade para que esta funcione inteiramente durante um longo período de tempo.
Adquira algumas peças necessárias, por exemplo, tampas redondas, grelhas de aspiração/exaustão, etc., antes da instalação da unidade.
HRV; Вентиляция с реãенерацией тепла
Внимательно ознаêомьтесь с данным рóêоводством и óстановите блоê надлежащим образом, чтобы он работал на полнóю
мощность в течение долãоãо времени.
Перед óстановêой блоêа подãотовьте необходимые детали, например êолпаê оêрóãлой формы, решетêи всасывания/выпóсêа
воздóха и т.п.

INSTALLATION MANUAL

With DX coil
VKM50GV1
VKM80GV1
VKM100GV1
HRV
English
Deutsch
Français
Español
Italiano
ΕλληνικÜ
Nederlands
Portugues
Рóссêий

Advertisement

Table of Contents
loading

Summary of Contents for Daikin VKM50GMV1

  • Page 1: Installation Manual

    English Total Heat Exchanger HRV (Heat Reclaim Ventilation) -with DX Coil- Deutsch MODELS (Ceiling mounted duct type) Français With DX coil & Humidifier With DX coil Español VKM50GMV1 VKM50GV1 VKM80GMV1 VKM80GV1 Italiano VKM100GMV1 VKM100GV1 ΕλληνικÜ HRV;Heat Reclaim Ventilation Nederlands Please read this installation manual carefully and install the unit properly to keep it at full capacity for a long time.
  • Page 2 3P155750-1...
  • Page 3: Table Of Contents

    With DX coil &Humidifier VKM50GMV1 With DX coil VKM50GV1 Installation Total Heat Exchanger VKM80GMV1 VKM80GV1 HRV(Heat Reclaim Ventilation) -with DX Coil- manual VKM100GMV1 VKM100GV1 • Use only accessories and manufacturer-specified parts CONTENTS when installing. The use of parts other than specified may cause drop of the unit, water leakage, electric shock, fire or other accidents.
  • Page 4: Before Installation

    • When installing the unit, have ready the round shape hood, the air discharge grille and the air suction grille, and other parts needed for the installation. Consult your Daikin dealer when selecting optional accesso- ries. English...
  • Page 5: Selecting Installation Site

    FOR THE FOLLOWING ITEMS, TAKE SPECIAL CARE SELECTING INSTALLATION SITE DURING CONSTRUCTION AND CHECK AFTER CAUTION INSTALLATION IS FINISHED. • When moving the unit during or after unpacking, make sure a. Items to be checked after completion of work to lift it by holding its hanger brackets. Do not exert any pres- sure on other parts, especially the refrigerant piping, drain If not properly done, Items to be checked...
  • Page 6: Preparations Before Installation

    Transportation Fig. 2 Double nut anchors Screw (mm) Model Fig. 4 VKM50GMV1, VKM50GV1 (2) If unnecessary, remove the four transportation VKM80GMV1, VKM80GV1 1214 1262 anchors. VKM100GMV1, VKM100GV1 • Loosen the screws. (2) Make sure the range of the unit’s external static pres- •...
  • Page 7: Drain Piping And Water Supply Work

    (4) Check the unit is horizontally level. CAUTION CAUTION Do not connect the drain piping directly to sewage pipes Use a level to make sure that the unit is level and that that smell of ammonia. The ammonia in the sewage might the tilt (downward slope) to the drain piping connection enter the indoor unit through the drain pipes and corrode is within 1°.
  • Page 8: Refrigerant Piping Work

    (4) Install the water supply piping. 〈 〈 〈 〈 VKM-GMV1 series only〉 〉 〉 〉 • Also, if the supply water is hard water, use a water soft- ener because of short life. CAUTION ∗ Life of humidifying element is about 3 years (4,000 hours), under the supply water conditions of hardness: When installing the water supply piping, wash the pipes with 150mg/l.
  • Page 9: Duct Connection

    • When connecting the flare nut, coat the flare section (both diameter diameter inside and outside) with ester oil or ether oil, rotate three or VKM50GMV1, VKM50GV1 four times first, then screw in. (Refer to Fig. 12) φ 12.7 φ 6.4...
  • Page 10: Electric Wiring Work

    (SA). Select AND WIRE materials keeping in mind the fan strength and operating sound of the unit. Consult your Daikin dealer for selection. Remote controller wiring Power supply wiring • Set the pitch between the exhaust air outlet (EA) and the out- Transmission wiring side air intake (OA) to 3 times the duct diameter.
  • Page 11: Wiring Example And How To Set The Remote Controller

    10 WIRING EXAMPLE AND HOW TO SET 10. 2 Connecting power supply wiring and ground wiring THE REMOTE CONTROLLER • Pass the power supply wiring and the ground wiring through 10. 1 OPENING AND SHUTTING THE ELECTRIC the wiring through-hole into the electrical parts box and secure with the included clamping material after connecting PARTS BOX AND CONNECTING THE WIRING the wires to terminal blocks.
  • Page 12 [4] Use round crimp-style terminals for connecting wires to the 10. 3 Remote power supply wiring, transmission wir- power supply terminal block. ing, computerised control wire If unavailable, observe the following points when wiring. • Pass the remote control wiring, the transmission wiring, •...
  • Page 13 〈 〈 〈 〈 Combined operation system with VRVII system (connected with HRV units and standard indoor units in a single refrigerant circuit)〉 〉 〉 〉 Outdoor unit Electric parts box IN/D OUT/D F1 F2 F1 F2 Power supply Power supply Power supply 220-240V 220-240V...
  • Page 14 [PRECAUTIONS] [PRECAUTIONS] There is not need to set the indoor unit address when using • Crossover wiring is needed when using group control and group control. (It is automatically set when the power is turned 2 remote controllers at the same time. on.
  • Page 15: Field Setting And Test Run

    EXAMPLE OF CONTROL WIRING (3) To make settings for individual units under group control (when mode No. 27, 28 or 29 is selected), press the TIMER Connecting line can be extended up to 50m maximum. SETTING ON/OFF button to select the “unit No.” for which the settings are to be made.
  • Page 16 I I I I Settings and setting numbers NOTE) Mode FIRST SECOND CORD NO. 1. The inside the frame indicates the second code no. Description of setting CORD set when shipped from factory. 01 02 03 04 05 06 07 ∗1 2.
  • Page 17 11. 2 Perform a test run according to the outdoor unit’s installation manual. (1) Make sure the electric parts box of the unit is closed before turning on power. (2) Make a test run following the operation manual of the outdoor unit.
  • Page 18: Wiring Diagram

    12 WIRING DIAGRAM English...
  • Page 19 English...
  • Page 20 3P130768-1B EM03A096A (0504)

This manual is also suitable for:

Vkm80gmv1Vkm100gmv1Vkm50gv1Vkm80gv1Vkm100gv1

Table of Contents