Toshiba Super MMU-AP0091H Service Manual page 257

Part to be
No.
exchanged
8 Attachment/
detachment of
pipe fixing
rubber
<Disassembling>
1) Hold the both ends (longitudinal direction)
2) Pushing in the claw side of SUS band with
<Assembly>
1) The fixing rubber is a segmentation system
2) Align the claw side of SUS band to slit side
3) Attach the band so that a clearance does
4) Fit the root of claw to the rubber lightly,
Work procedure
REQUIREMENT
Put on gloves during working; otherwise an
injury may be caused by parts, etc.
of the rubber lightly, and then make a
margin between SUS band and fixing
rubber.
fingers, the claw comes off from the square
hole.
due to freedom degree of combination.
Therefore, for assembly, it is recommended
to fit both pipes including the fixing rubber
after passing the rubber through the pipes
separately. In this time, check both slit direct
the same direction.
of the rubber for assembly. (Assembly in
reverse direction is also available, but the
work performance decreases.)
not generate between SUS band and fixing
rubber. Especially pay attention not to
generate a clearance at part of the hair pin
side of the band.
push R part at square hole side toward the
arrow mark, and then hook the claw to the
square hole.
(If it is not hooked, recheck 3) there is no
clearance between band and rubber.)
1)
Compress rubber and make margin.
2)
Push in the band toward arrow mark.
Align direction of the slits,
and then attach to each pipe.
1)
Align the claw to slit side of the rubber.
2)
3)
Slide the square hole side
toward arrow mark.
4)
Push claw side against the rubber.
257
Remarks
1)
Matching the claws, slide them.
Slide it.
Push the band against
rubber without clearance.