Cleaning Of Discharge Louver - Toshiba Super MMU-AP0091H Service Manual

Cleaning of discharge louver

The air outlet flap can be removed to clean if necessary.
1
Remove the air outlet flap.
• Holding the both ends of the air outlet flap,
remove it with sagging the center downward.
2
Clean the air outlet flap with water.
• If dirt is heavy, clean the air outlet flap by tepid
water with neutral detergent or water.
3
Mount the air outlet flap.
• First push in the one side, and insert the
opposite side with sagging the center down-
ward.
Be careful to direction when mounting
the louver.
Set the surface with printed mark upward, and
mount the flap so that the arrow mark of the
printed mark directs outward.
[2-way Air Discharge Cassette Type]
• Hold the center panel and pull it toward you and
pull down it slowly downward. (The center panel
can move either leftward or rightward. Remove it
after confirmation.)
• Take off the fall-preventing straps at the both sides.
• Pull down the air filter to take out it.
[
For AP0631, AP0481, and AP0561 types, hold
the claw of the air filter and pull down it.
After cleaning, be sure to attach the fall-preventing straps of the center panel; otherwise an injury is caused
by falling.
1
2
3
1
Insert
[1-way Air Discharge Cassette Compact Type]
1. Push [PUSH] at the center and left/right of the
suction port to open the suction port.
2. Take out the air filter by lifting up it once and then
pull it downward.
]
REQUIREMENT
• Insert the air filter of 1-way Air Discharge Cassette
Compact Type surely into the specified position.
CAUTION
49
2
Insert in the flap sagging
down the center downward.