Hitachi AMS 2500 Getting Started Manual page 32

If You Need to Power Off the Base and Expansion Units
Use the following procedure:
WARNING! Do not remove the power cords from the rear of the base unit
without first setting the Hitachi switch to the OFF position.
a. Stop all host I/O to the base and expansion units.
b. Press the Power switch on the lower right side of the base unit front
panel to the OFF position:
c. Confirm that the Power LED is OFF.
d. Turn off all breakers.
e. Remove the power cables from the power receptacles on the base
unit rear panel.
f. Verify that the green LEDs above each power receptacle on the rear
panel are OFF and that the green READY LED on the front panel is
OFF.
Recording Configuration Settings
We recommend that you make a copy of the following table and record your
configuration settings for future reference.
Array Name
Email Notifications
Domain Name
Mail Server Address
From Address
Send to Address
Address 1:
Address 2:
Address 3:
Reply To Address
30
Table 1-4: Recording Configuration Settings
Field
Email Notifications

Disabled

Enabled (record your settings below)
Hitachi AMS 2500 Getting Started Guide
Description