Hitachi AMS 2500 Getting Started Manual page 26

e. In the IP Address OR Host Name of controller field, enter the
same controller IP address(es) recorded in
Refer to the note on
directly connected to a management port on one controller or
connected via a switch or hub.
f. Click OK.
g. Click Close.
Create RAID Groups, Logical Units, and Host Groups
The following sections describe how to create RAID groups, logical units,
and host groups. For additional information, refer to the Navigator 2 online
help.
a. If the Common Array Tasks area is not displayed, click the storage
unit under the Array Name column
b. In the Common Array Tasks area, click Create Logical Unit. The
Create & Map New Volume wizard starts.
c. When the introductory page appears, click Next. The page in
Figure 1-22 on page 25
24
Figure 1-21: Example of Edit Array Page
page 20
appears.
Hitachi AMS 2500 Getting Started Guide
Table 1-4 on page
regarding management consoles
30.