Receiving Radio Broadcasts; Tuning In Stations Manually; Using Preset Tuning - JVC RX-7010VBK Instructions Manual

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel:
1. Press FM/AM to select the band
(FM or AM).
The last received station of the selected band
is tuned in.
• Each time you press the button, the band alternates between
FM and AM.
SPK 1
L R
ANALOG
2. Press FM/AM TUNING 5/ ∞until
you find the frequency you want.
• Pressing FM/AM TUNING 5 increases
the frequency.
• Pressing FM/AM TUNING ∞ decreases
the frequency.
From the remote control:
1. Press FM/AM to select the band.
• Each time you press the button, the band
alternates between FM and AM.
2. Press TUNING +/– until you find
the frequency you want.
• Pressing TUNING + increases the
frequency.
• Pressing TUNING – decreases the
frequency.
Note:
When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
When an FM stereo program is received, the STEREO indicator also
lights up.
FM/AM
VOLUME
TUNED
FM/AM TUNING
FM/AM
TUNING

Using Preset Tuning

Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.
To store the preset stations
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Tune in the station you want to preset (see
"Tuning in Stations Manually").
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting the
FM Reception Mode" on page 19.
SPK 1
L R
ANALOG
2. Press MEMORY.
SPK 1
L R
ANALOG
CH-
"CH-" appears and the channel number position starts flashing
on the display for about 5 seconds.
3. Press FM/AM PRESET 5/ ∞ to
select a channel number while the
channel number position is flashing.
SPK 1
L R
ANALOG
CH-
Note:
You can use the 10 keys on the remote control to select the preset
number. When using the 10 keys, be sure that they are activated
for the tuner, not for the CD and others. (See page 31.)
4. Press MEMORY again while the
selected channel number is flashing on
the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
SPK 1
L R
ANALOG
CH-
5. Repeat steps 1 to 4 until you store all the
stations you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
VOLUME
TUNED
MEMORY
VOLUME
TUNED
FM/AM PRESET
VOLUME
TUNED
MEMORY
VOLUME
TUNED
18