iCharger 3010B User Manual page 11

iCharger Synchronous Balance Charger/Discharger
Key Beep
Buzzer
Dec
Dec
Inc
Completion Ring
Beep always
-
Dec
Dec
Inc
Back-light
Cooling fan AUTO
-
Dec
Dec Inc
Discharge reduce
OFF
- +
-
Delay 0min
Dec Inc
Dec
Dec Inc
Regenerative DSC
OFF 1.0A 4.50V
- + - +
-
Delay 0min
Dec Inc Dec Inc Dec
Dec Inc
When Regenerative discharge is set to ON, discharging by charger internal consumption turns to charging
power supply (current and voltage limit can be set), which is shown in the following graph.
+ +
Regenerative DSC: OFF
Power
Input
Supper
iCharger
- -
Regenerative discharge OFF
Note:
1． When in Regenerative discharging, charger's power supply needs to be
Pb battery can be used for input power supply, but switch power adapter cannot.
2． The setting of regenerative discharge's current and voltage limit should be suit for power supply. For
example, using 12V Pb battery as power supply, the regenerative current and voltage should not be more
than its max charging current and voltage, or
3． Regenerative discharge max power is the same with charger's setting max charging power, not
discharging power. (Restricted by setting regenerative discharge current and voltage limit, and discharge
current limit.)
4． Regenerative current limit is
5． If input power supply voltage is more than setting regenerative limit voltage, charger will not start
regenerative discharge and internal discharge instead.
Key confirmation and alert tone. If the keyboard sound is ON there will be a
ON
beep when you press any key. If the buzzer is ON the iCharger will
generate an alert tone for certain events.
ON
Key Beep: OFF&ON: (ON, default)
- +
Buzzer: OFF&ON: (ON, default)
Inc
Process completion tone. Controls the tones generated at end of charging
or discharging and the cyclic charging/discharging indication.
Options: Beep 5 times, Beep 3 minutes, Beep always (continuous until
user presses STOP), Beep OFF
+
(Beep always, default)
Inc
Back-light and cooling fan control. Adjust the LCD backlight brightness.
50%
There are three cooling fan modes: ON, OFF, AUTO. In AUTO-Mode,
iCharger adjusts the fan automatically to control its internal temperature.
Cooling fan: OFF, ON & AUTO (AUTO, default)
+
Inc
Discharge reduce setting. When you set it to ―ON‖，If the final voltage target
storage voltage is reached, the buzzer will beep for three times, and the left
of the second line display "D>>", and the charger enters into the high
precision discharge process. The process won't stop until the current
50%
reaches xx% of the configured discharge current.
+
Reduce: ON, OFF
Inc
Regenerative discharge setting. In the second line, these items are set:
Regenerative discharge ON/OFF, current limit, voltage limit.
Regenerative discharge: OFF, ON (OFF, default)
Regenerative current limit: 1 – 30A (1A, default)
+
Inc
Regenerative voltage limit: 4.50 – 37.0V (4.50V, default)
+
+
User
Discharge
Output
Batt.
Current
Pack
-
-
not very accurate
Range: 1 – 99％
+
Rechargeable
Power Supper
For example:
Pb battery etc.
-
Regenerative discharge ON
it may cause danger
, which may be 20% difference, max.
-11-
+ +
Regenerative DSC: ON
Discharge
Input Output
Current
iCharger
- -
rechargeable
. For example,
.
3010B
+
User
Batt.
Pack
-