Charging A Lithium Battery In Normal Charge Mode; Fast Charging A Lithium Battery - iCharger 3010B User Manual

Synchronous balance charger/discharger

Hide thumbs

Table Of Contents

Table of Contents

iCharger Synchronous Balance Charger/Discharger

Charging a Lithium battery in normal CHARGE mode

The iCharger first charges with constant current (CC) according to the user setting then constant voltage (CV)

when the charging voltage reaches the peak point. In the CV phase the current gradually falls. The iCharger

will terminate charging when the current falls below than 1/10 of the configured charge current.

LiPo CHARGE

1.0A

11.1V(3S)

Dec

Inc

Dec

Inc

Batt type

Start/Enter

>3 seconds

stop

R:02SER S:03SER

CONFIRM(ENTER)

Batt type

Start/Enter

stop

Battery

V-BP

Charge

Li03 1.0A 12.60V

Series

Current

CHG 00993 59m:51

work

charged

charging

State

capacity

time

number

charge

of cells

current

Fast charging a Lithium battery

The iCharger first charges with constant current (CC) according to the user setting then constant voltage (CV)

Series

when the charging voltage reaches the peak point. In the CV phase the current gradually falls. The iCharger

will terminate charging when the current falls below than 1/5 of the configured charge current. This will result

in slightly less than 100% charge but will complete sooner than the Normal charge mode.

LiPo FAST CHARGE

1.0A

11.1V(3S)

Dec

Inc

Dec

Inc

Batt type

Start/Enter

stop

>3 seconds

R:02SER S:03SER

CONFIRM(ENTER)

Batt type

Start/Enter

stop

Battery

V-BP

Charge

Li03 1.0A 12.60V

Series

Current

FST 00993 59m:51

work

charged

charging

State

capacity

time

number

charge

battery

of cells

current

voltage

Series

The left side of the first line set the type of battery (LiPo, Lilo or LiFe). The

value on the left side of second line sets the charge current and the value

on the right side of second line sets the cell count and voltage of the battery

pack. After setting the current and voltage, press Start/Enter for more than

3 seconds to start the next process.

Inc

Charge current: 0.05 – 30A, Voltage: 1 – 10 series ( LiFe to 12 series)

The number of cells you set and the processor detects. If the checking

result is the same, it would enter to the next interface; if not the same, the

left side of the first line 'R:xxSER' shows the number of cells detected by the

iCharger and the right side of the first line 'S:xxSER' is the number of cells

set by the user. Usually, the auto-detect number won't exceed the number

set by the user. You should make sure that the configured number and the

actual number for the battery are the same and then you can start charging

by pressing Start/Enter. If not, press Batt type/Stop to go back to the

previous screen and adjust the setting.

Lithium CHARGE mode. The screen shows the status during the charging

process. You can stop charging at any time by pressing Batt type/Stop.

Press Inc to display each cell's voltage (see the balance voltage

information) and press Dec to display the General Status information.

battery

voltage

The fast charging mode of Lithium battery. The left side of the first line set

the type of battery (LiPo, Lilo or LiFe). The value on the left side of second

line sets the charge current and the value on the right side of second line

sets the cell count and voltage of the battery pack. After setting the current

and voltage, press Start/Enter for more than 3 seconds to start the next

Inc

process.