Wlan Module Removal; Wlan Module Installation - Packard Bell EasyNote LS11HR Service Manual

WLAN Module Removal

Prerequisite:
Base Door Removal
1.
Locate module (A) on lower cover (Figure 3-9).
2. Disconnect antenna cables, (B) main and (C) auxiliary from WLAN module.
3. Remove screw (D) from module.
4. Remove WLAN module (A) from mainboard connector (E).
5. Remove WLAN module (A) from mainboard connector.
Figure 3-9. Removing the WLAN Module
NOTE:
NOTE:
Main (black) antenna connector is located nearest battery bay. Auxiliary (white)
antenna connector is located nearest HDD module.

WLAN Module Installation

1.
Insert module (A) into mainboard connector (E) (Figure 3-9).
2. Install and secure screw (D) to module.
3. Attach antenna cables, (B) main and (C) auxiliary to WLAN module.
4. Install base door.
ID Size
D M1.98*3
Machine Maintenance Procedures
E
A
Quantity
1
0
D
B
C
Screw Type
0
3-15