Upper Cover/Keyboard Installation - Packard Bell EasyNote LS11HR Service Manual

11. Peel back mylar and remove four (4) screws (F) from support plate (G).
12. Slide support plate (G) to release flanges from support plate slots.
NOTE:
NOTE:
Make sure not to damage keyboard FPC cable when removing keyboard support plate.
13. Remove support plate (G).
14. Remove keyboard from upper cover.
D
F
F
Figure 3-21. Keyboard

Upper Cover/Keyboard Installation

1.
Place keyboard onto upper cover.
2. Feed cable (B) through support plate opening (H). Lower support plate (G) into place
(Figure 3-21).
3. Slide support plate hinges into upper cover slots.
4. Install and secure four (4) screws (F) to support plate (G). Cover with mylar.
5. Install and secure three (3) screws (E) to support plate (G). Cover with mylar.
6. Install and secure three (3) screws (D) to support plate (G).
7. Hold keyboard in an angle above computer and connect FPC cable (B) to mainboard
(Figure 3-20).
8. Lower keyboard into place and press on edges to secure.
9. Connect power board FFC cable (C) to mainboard
10. Install and secure four (4) screws (B) to battery bay
11. Install and secure eleven (11) screws (A)
12. Install palmrest.
3-24
D
F
G
E
F
E
B
E
H
(Figure 3-19).
(Figure 3-18).
(Figure 3-18).
Machine Maintenance Procedures
0