Thermal Module Installation - Packard Bell EasyNote LS11HR Service Manual

Thermal Module Installation

+
IMPORTANT:
Apply suitable thermal grease and ensure all heat pads are in place before
replacing module.
The following thermal grease types are approved for use:
N302 I-Connosseur
Honeywell
The following thermal pads are approved for use:
Eapus XR-PE
1.
Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab and Isopropyl
Alcohol, Acetone, or other approved cleaning agent.
2. Apply small amount of thermal grease to center of CPU (B)
NOTE:
NOTE:
Force used during installation of thermal module is sufficient to spread grease over
CPU top.
3. Align module (A) to mainboard screw holes.
4. Install and secure four (4) screws (B) in numerical order from 1 to 4 to mainboard
(Figure 3-30).
5. Install and secure two (2) screws (C) 5 and 6 to mainboard. Refer to
6. Install mainboard.
ID Size
C M2.5*3 Ni
B THML_SPRING_SCREW_
ASSY
Machine Maintenance Procedures
(Figure
Quantity
2
4
3-31).
(Figure 3-30).
Screw Type
3-35
0