Check The Engine Belt - Ford Models - Genie Z-45/25 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE A PROCEDURES
A-23
Check the Engine Belt -
Ford Models
Engine specifications require that
this procedure be performed every
200 hours.
Maintaining the engine belt is essential to good
engine performance and service life. The machine
will not operate properly with a loose or defective
belt and continued use may cause component
damage.
Bodily injury hazard. Do not
inspect while the engine is
running. Remove the key to
secure from operation.
Burn hazard. Beware of hot
engine components. Contact with
hot engine components may result
in severe burns.
1 Remove the safety pin (if equipped) from the
engine pivot plate latch.
The engine pivot plate latch is
located under the engine turntable
pivot plate at the counterweight
end of the machine.
2 Open the engine pivot plate latch and swing the
engine pivot plate out and away from the
machine.
4 - 28
3 Inspect the engine belt for:
· Cracking
· Glazing
· Separation
· Breaks
4 Replace belt if any damage is found.
5 Swing the engine back to its original position
and close the engine pivot plate latch.
6 Install the engine pivot plate safety pin
(if equipped).
Engine belt - Genie part number
Ford Models
Genie Z-45/25 & Genie Z-45/25J
First Edition • Second Printing
Ford LRG-425 EFI engines are
equipped with a serpentine belt
and incorporate a self adjusting
belt tensioner. No adjustment is
required.
Part No. 52709
52580