Pioneer PDP-425CMX Technical Manual page 61

Regarding the stand pipe screw holes when the stand is
used as a desktop stand
Stand pipe screw holes when the stand is used as a desktop
stand:
• Specifications .............................................. Normal use
• Screw holes used with stand orientation ... A, A'
Note
Screw holes B and B' are for attaching options (available sepa-
rately).
2 Hook the stand pipe holes A onto the screw heads of the installation bolts 1. Slide the stand up the main Plasma
Display until it engages the installation bolts 1. Once joined, the stand stops sliding at 19 mm.
3 Pass the installation bolts 2 (M8 × 40) through the stand pipes are A–A').
4 Tighten the installation bolts 1 securely with the provided hexagonal wrench.
1. Place a sheet or protective cover to protect the display from scratches or damage.
2. Assemble only with the Plasma Display lying flat on a table or similar surface.
3. Do not apply excessive pressure when tightening the bolts.
Cautions
4. Move the stand so that the screw holes on the stand line up with nuts on the display panel.
5. The display weighs approximately 30 kg (66 lbs.) or more and has little depth, making the display
very unstable. For this reason at least two people are necessary for its setup and installation.
Table top stand
B
A
B ´
A ´
Installation bolts 2 (M8 × 40)
Slide the stand
Sheet
Table Top Stand: PDK-TS01
B
A
B ´
A ´
61