How To Initialize The Blu-Ray Disc Player - FUNAI B4-M500 Service Manual

HOW TO INITIALIZE THE BLU-RAY DISC PLAYER

To put the program back at the factory-default,
initialize the BD player as the following procedure.
Note:
• By initializing, network is reset to disconnected state
and "Network Service Disclaimer" appears on the
screen.
• Once the unit is initialized, the unit starts from
Initialization the next time it is turned on. The
Initialization allows quick set up of language and
network settings. To exit this mode, select "Cancel"
on the screen.
1. Turn the power on.
2. Remove the disc on the tray and close the tray.
3. Press [G] (skip up), [1], [2], and [3] buttons on
the remote control unit in this order.
Fig. a appears on the screen.
Version Display
F/W Name : *******
Version : *.**.**
Region : *-*
Pickup : **
Default Setting : --
Default Setting : STOP
VFD/LED Check : OK
4. Press [ C ] button on the remote control unit.
Fig. b appears on the screen.
Version Display
F/W Name : *******
Version : *.**.**
Region : *-*
Pickup : **
Default Setting : SUCCESS
Default Setting : STOP
VFD/LED Check : OK
5. After initializing, the power will turn off
automatically.
" * " differ depending on the models.
End : STANDBY-ON
Fig. a
" * " differ depending on the models.
End : STANDBY-ON
Fig. b
1-6-1 ECB91_93_95INT