Service Program Mode Operation - Ricoh B205 Service Manual

SERVICE PROGRAM MODE

5.1.2 SERVICE PROGRAM MODE OPERATION

The service program mode is used to check electrical data, change modes, and
adjust values. Two service program modes are provided:
• SP Mode (Service). Includes all the options in the SP displays for normal
maintenance and adjustments.
• SSP Mode (Special Service). Includes the normal SP modes and some
additional options in the SP displays not required for normal settings and
adjustments. (Most are marked "DFU" in the following tables.) Do not change
these important settings needlessly. For details, contact your supervisor.
Entering and Exiting SP mode
Press the Clear Mode key.
Use the keypad to enter "107".
Hold down Clear/Stop for at least 3 seconds.
Enter the Service Mode.
To enter the Normal Service Mode:
Copy SP On the touch-panel, press Copy SP.
To enter the Special Service Mode:
Copy SP Hold down
Exit Press Exit twice to return to the copy window.
NOTE: Use SP2902 to perform test pattern printing. ( 5.1.4)
B205/B209/D007/D008
and then press Copy SP.
5-2 SM