Display Section - Panasonic CZ-RTC2 User Manual

3. Timer Remote Controller

Display Section

(Refer to the page 3-35)
1. (Setting) indication
Appears when the timer program is being set.
2. (Unit) indication
Indicates the unit No. of the indoor unit which is selected
with the Unit select button, or the unit in which an abnor-
mality occurs.
3. (Timer No.) indication
Appears when the time program is being set.
4. Timer program indication
: The indoor unit starts operation at the programmed
time.
: The indoor unit stops operation at the programmed
time.
5. (Today's day of the week) indication
Indicates today's day of the week.
6. (Program schedule) indication
Appears under days that are scheduled for program op-
eration.
7. Present time indication
Displays the present time on a 24-hour clock. Also, dis-
plays settings in the various setting modes.
8. (Timer off) indication
Displayed when the timer has been turned OFF.
9. (Error) indication
Displayed when a mistake is made during timer setting.
10. (Outing) indication (
Appears when the outing function is set.
11. Upper and lower limit indication of the outing func-
tion
: Indicates the upper limit of the temperature
: Indicates the lower limit of the temperature
12. Operation Mode indication
Displays the selected operation mode. (AUTO
/DRY /COOL /FAN
13. Temperature indication
Indicates the set temperature.
14. °F / °C (Temperature unit) indication
15. (Remote control sensor) indication
Appears when the remote control sensor is used.
16. (Centralized control) indication
Appears when operated in centralized control. If the
remote control operation is not permitted to the remote
unit, when the Start/Stop button, Mode select button or
Temperature setting button is pressed,
rejects the change.
Outing function)
/HEAT
).
fl ashes and
17. (Operation mode change control) indication
Displays when an operation mode is entered by the re-
mote control unit, while another operation mode has been
already selected. This indicates that the operation mode
cannot be changed.
18. (Disabled feature) indication
Displayed if the selected feature was disabled during
installation.
19. (GHP operation standby) indication
Appears during standby if a gas heat pump air conditioner
is used.
20. (Heating standby mode) indication
Appears when the fan of the indoor unit is stopped or in
low fan speed.
21. / / /
The selected fan mode is displayed.
22. (Swing) indication
Appears while the fl ap swings.
23. (Flap position) indication
Indicates the fl ap position.
24. (Filter) indication
Appears when fi lter needs cleaning. Clean the fi lter.
25. (Maintenance function) indication
Appears when the maintenance function (monitoring sen-
sor temperatures) is activated.
26. (Ventilation) indication
Appears when a fan available in the market is installed
and is operating.
27. (Oil) indication
Appears when the engine oil needs to be changed. (Ap-
pears when the gas heat pump air conditioner is used.)
28. (Sleeping) indication
Appears during the sleeping function.
29. (Caution) indication
Appears when the protective device is activated or when
an abnormality occurs.
30. Unit No. indication
Indicates the unit No. of the selected indoor unit.
31. (Test) indication
Appears while in test operation.
3-37
Control of 2WAY SYSTEM
(Fan mode select) indication
1
2
3
4
5
6
7
8
9