Page 1
Basic Functions of theCZ-RTC2Remote Controller 1. Start/Stop Button: Pushing this button starts and pushing again stops the unit. 2. Operation Lamp: This lamp is turned on when the air conditioner is in operation. This lamp blinks when an error occurs or a protective device has activated. Operation lamp Start / Stop Button 3.
Page 2
Heating Mode: This mode is used for normal heating operation. Standby: For several minutes after the start of heating operation the indoor fan will not start running(or at very low speed) until the indoor heat exchanger has warmed up sufficiently. This prevents a cold air draft from entering the space.
Dry Mode: During the Dry operation the system adjusts the room temperature and the fan speed automatically according to the conditions in the room, in order to maintain a comfortable room environment. Dry Mode Icon Note: There is no humidity sensor in the indoor unit. The system automatically controls the compressor and indoor fan.
Page 4
5. Fan Speed Button: Use this button to adjust the fan speed between Auto, High, Medium and Low speed. Each time the Fan Speed Button is pressed will cycle it through the available speeds. Auto mode: The air conditioner will automatically decide on the fan speed according to the room temperature conditions.
Page 5
6. Swing/Air Direction Button: This button adjusts the swing direction to the flap (If Applicable) on the indoor unit. The air direction can be adjusted to a fixed position or set to auto to “sweep” continuously. Swing/Air Direction Button Note: The flap is directed up during the heat Standby.