Maintenance And Service - JEI MAGBEAST HM40 Operation & Safety Manual

JEI SOLUTIONS LTD

6. MAINTENANCE AND SERVICE

To avoid accidents the drill stand, power cable, wiring, plug connectors, and
switches must be regularly inspected for damage.
 Perform adjustment of the machine play guides every 50 hours or as
necessary performed by the regulation screws. Slide guide loose is correct if
the drive can be moved smoothly by using the lever. It's not accepted to
automatically slide down under its own weight. (see point 4.10)
 Every 100 hours of work check condition of carbon brushes. If their length is
less than 5 mm they should be replaced for original new ones. After
replacement new brushes should be run-in without load for about 20 min.
Other repair work should be done only by authorized service points, appointed
by distributor. Replacement of brushes is possible without removal motor unit
from the unit. (see 5.2)
 Lubricate regularly brass slide guide inserts with grease as well as the rack
and pinion.
 To prevent the machine from rusting (especially when used outdoors) all steel
parts should be covered with thin layer of grease film
 Damaged machine parts to be exchanged only to original parts.
 New spare parts order: required to enter the code or send the damage part
with information about type of drilling machine and power supply.
5.2 (20130122) Operators manual for Drilling Machine Magbeast HM40
MAGBEAST HM40
- 21 -