Table of Contents
Advertisement
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN
9.2.1.
Service Mode Table 1
Mode Name
Jitter check
Jitter check.
Jitter rate is measured and displayed.
Measurement is repeatedly done in
the cycle of one second. Read error
counter starts from zero upon mode
setting. When target block data failed
to be read out, the counter advances
by one increment. When the failure is
caused by minor error, it may be
corrected when retired to enable
successful reading. In this case, the
counter advances by one. When the
error persists even after retry, the
counter may jump by two or more.
FL Display sequence
Display 1 → 2
Error code check
Error code check.
The latest error code stored in the
EEPROM IC is displayed.
Note: Refer to "Section 9.3 DVD Self
Diagnostic Function Error Code" for
more details information on the error
codes.
Item
Description
FL Display
(Display 1)
Jitter rate is shown in decimal notation to
one place of decimal.
Focus drive value is shown in hexadecimal
notation.
(Display 2)
Error code (play_err) is expressed in the
following convention.
Error code = 0 x DAXX is expressed: →
DVDnn U12
Error code = 0 x DBXX is expressed: →
DVDnn H12
Error code = 0 x DXXX is expressed: →
DVDnn F123
Error code = 0 x 0000 is expressed: →
DVDnn F---
* "xx" denotes the error code
28
Key Operation
Front Key
In STOP (no disc) mode, press
[
] button on the main unit,
and [5] button on the remote control
unit.
Press [
] button to exit.
In STOP (no disc) mode, press
[
] button on the main unit,
and [0] button on the remote control
unit. *With pointing of cursor up and
down on display.
Cancelled automatically 5 seconds
later.
To exit, press [
] button on main
unit or remote control.
Advertisement
Table of Contents
