Using Mdc; Configuring Settings For Multi Control - Samsung ME95C User Manual

Chapter 04

Using MDC

Configuring Settings for Multi Control

MENUm→
Wake On LAN(WOL):
Assign an individual ID to your product.
This feature allows you to power on the
product by sending a pre-determined
command from an external system to the Configuring settings for Multi Control
product over a network.
Make sure the network is capable of data
communication with the PC that sends
the command to the product. Ensure you
have a program that can generate Wake
on LAN signals.
System → Multi Control → ENTERE
ID Setup
•
Assign an ID to a set. (Range: 0~99)
Press ▲/▼ to select a number, and press E.
ID Input
•
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
MDC Connection
•
Select a method to connect to MDC to receive the MDC signal.
RS232C MDC
-
Communicates with the MDC via a RS232C MDC cable.
RJ45 MDC
-
Communicates with the MDC via an RJ45 MDC cable.
― If
MDC Connection is set to RJ45 MDC
― The WOL function is enabled only when
and the product is powered off, only the WOL function will be enabled. MDC communication will not be available.
MDC Connection RJ45 MDC.
is set to
58