REQUIRED FOR OPERATION THINGS NEEDED You will need to buy a few items to start the engine and run the car. • Use 20% nitro CAR fuel. Do not use airplane fuels, they will over heat engine. • Buy short glow plugs, like O.S. 8. Or OFNA/PICCO P-7S plug. Use plugs without idle bar.
Page 3
READ THIS BEFORE RUNNING Running a nitro kit is fun and easy, but to make this a safe rusting. • Clear oil and dirt from chassis with a degreaser. and good experience you must observe a few rules. This kit is extremely fast, easily over 40MPH, and can seriously Precautions injure someone if you are not careful.
Page 4
INSTALLATION OF THE RECEIVER BATTERY Antenna Wire Antenna Pipe AA-3 Batteries 4 pcs Receiver battery pack * Check negative and positive-side before assembly. ( Engine at Idle ) CHECKING ENGINE THROTTLE 1. Insert AA batteries into 1. Pull Full Throttle. 1.
ASSEMBLY OF THE TIRES AND WHEELS 37390 37640 Front "C" Hub 2 x 10.8 Assembly 87650 WHEELS, 12 SPOKE, WHITE 37590 Drive Nut ( Plastic ) Nylon Nut 37390 2 x 10.8 PARTS USED 87660 Street Tire 37390 37740 2 x 10.8 Pin Rear Hub Assembly 37590...
Page 6
ENGINE BREAK-IN AND TUNNING (BREAK-IN THE ENGINE BEFORE DRIVING THE CAR!) • Choose a wide clear outdoor location with low dirt and dust. • Set the car on box or holder with wheels off the ground. • Turn on radio and car. Make sure throttle is at idle position. •...