Handling; Connection; Operation; Configuration - EMS CG-ARM7 User Manual

CAN/CAN - Gateway
2

Handling

2.1 Connection

The CG-ARM7 possesses a multiway connec-
tor for flexible wiring of the CAN interfaces and
the power supply. The RS232 interface on the
device is used for programming and for the
output of diagnostic information. For normal
operation it is not required.
The connector assignment of the multiway
connector and the RS232 interface is located
in chapter "3.1 Pin assignment" in this manual
or on your devices front panel.

2.2 Operation

To start up the gateway just connect the power
supply, the device starts automatically. As
soon as the automatic diagnostics is comple-
ted successfully, the green power LED lites up
permantly.
Important note: Ex factory the device offers
no configuration and must be configured befo-
re it is first run. Configuration instructions for
the gateway are located in chapter "2.3 Confi-
guration".

2.3 Configuration

The gateway configuration process consists of
two steps:
•
2
Creating a configuration file
CG-ARM7/RMD
User Manual