Display - EMS CG-ARM7 User Manual

CG-ARM7/RMD
Optional device settings
If the CG-ARM7 is password protected, you
must activate the field "password" and fill in the
correct password. Depending on the security
level, it is possible to request information about
the device even without password.
If CAN has been chosen as the PC interface
the "Inbound Program Identifier" (pidin), the
"Outbound Program Identifier" (pidout) and the
frame format for the program identifiers have
to be set. At last the serial number or the confi-
gured device id of the device has to be inscri-
bed for explicit identification. If you use only
one gateway in the network, you can also ins-
cribe the value '0' here. Never use the value
'0', if there are more than one CG-ARM7 gate-
ways in the network.
Starting the download:
To start the download process press start. The
operation may take a while, do not disconnect
the power supply to the device during the con-
figuration process. At that time the routing
functionality of the gateway is deactivated. Af-
ter successful completion no status message
is displayed. If an error occures a status mes-
sage is displayed.

2.4 Display

The device status is displayed by three LEDs.
Power
On
User Manual
CAN/CAN - Gateway
The device is in normal operation
mode. Routing of CAN messages is
enabled.
13