Before using the SSE P1 Pendant, it must first be charged, then registered to a
compatible base. Finally, to get the most out of the SSE P1 Pendant's features,
it is strongly recommended that emergency contact numbers are stored in the
phonebook of the compatible base.
# Throughout the remainder of this manual the SSE P1 Pendant will be
referred to as the Pendant.
Charging Your Pendant
The battery for the Pendant is pre-installed.
1. Connect the AC adaptor to the charger's DC IN 5.4V jack.
2. Plug the other end of the adaptor into a standard 240V AC power outlet.
3. Place the Pendant on the cradle with the HELP button facing forward while
charging.
# Charge the Pendant
completely (about 3 hours)
before using.
# Do not charge the
Pendant when the ambient
temperature is below 0°
C (32°F) or above 40°C
(104°F).
Status LED Indication
Blue
Red
Blinking Red
Blinking Blue
Blinking Blue rapidly
Blink Blue and Red
# The LED lights only when the Pendant is being used. The Pendant
automatically powers off after 2 minutes of inactivity.
6
GETTING STARTED
What it means
Charged
Charging
Battery is low
Successfully registered
During a call
During the registration process