Uniden XDECT TE-SSE35 Setup Manual

1 Unpack the telephone

Remove the cordless handset, charger base and all components from the packaging.
Remove the protective plastic from front of the charger and handset.
Remove the printed tag from underneath the charger.

2 Install batteries in the cordless handset

Remove the battery cover from the back of the handset by pressing on the notch and
sliding the cover down and off.
To connect the battery pack, insert the connector into the jack located inside the handset
as shown (the connector will only fit one way). Push until it clicks into place.
Tug gently on the wires to make sure the connection is secure.
Place the battery pack into the battery compartment and replace the cover by sliding up
and into place. Do not attempt to remove the batteries from the white plastic casing.

3 Connect the power cord

Find the power adapter.
Turn the charger upside down and connect into the socket marked
Plug the adapter into your wall socket (standard 240V power)
and turn on power at the wall.

4 Connect the telephone cord

Find the telephone cord. Connect the telephone line by inserting one
end into the charger at the socket marked
Insert the other end into your standard wall telephone connection.
Cordless Telephone
Uniden XDECT
TE-SSE35
BaS ic S ET-u p g u i d E
TEL LINE.
www.evadale.com.au
DC IN 9V.
AC adapter to
power socket
For more information
or to order, freecall
1300 883 194
©2012 Evadale Healthcare. All rights reserved.
PAGE
1 of 4
DESK
DESK
to wall
telephone
connection