Table of Contents
Advertisement
UX-L46V/UX-L36V
Removing the C.D. gear (1), (2) and (3)
Prior to performing the following procedure, remove
the CD servo board.
1.
Remove the two screws G attaching the CD base on
the bottom of the loading base.
2.
Remove the rear part of the CD base upward and
pull out the shaft f of the CD base from the camplate
on the front side of the loading base.
REFERENCE:
The CD mechanism assemly comes off
with the CD base.
3.
Remove the leaf spring on the upside of the loading
base.
4.
Remove the screw H attaching the cam plate fitting.
5.
Remove the screw I and the cam plate upward.
6.
Remove the belt from the C.D. gear (1).
7.
Pull out the C.D. gear (1), (2) and (3) respectively.
Cam plate fitting
H
Cam plate
Spring
Fig.15
1-20
(See Fig.13~16)
Loading base
I
G
CD base
(Bottom)
Fig.13
CD mechanism assembly
f
G
Fig.14
C.D. gear (3)
Belt
C.D. gear (2) C.D. gear (1)
Fig.16
G
Loading base
G
CD base
Advertisement
Table of Contents
