Table of Contents
Advertisement
Removing the loading motor / loading
motor board
Prior to performing the following procedure, remove
the clamper base / tray and the CD servo board.
1.
From upside of the loading base, remove the belt
from the motor pulley.
2.
Remove the two screws F
motor.
3.
At the bottom of the body, release the three joints d
outward and pull out the loading motor board from
the shaft. The loading motor comes off with the
loading board.
4.
Unsolder the two soldered points e on the loading
motor board and remove the loading motor.
REFERENCE:
When removing the loading motor board
only, unsolder the two soldering e on the
loading motor and release the three joints d.
(See Fig.11, 12)
attaching the loading
Loading motor
Belt
Fig.11
Soldering e
d
Loading motor
Loading motor board
Fig.12
UX-L46V/UX-L36V
F
Motor pulley
F
c
1-19
Advertisement
Table of Contents
