Makita BBC231U Instruction Manual page 11

- Blinking
- Lighting On
Blinking
Lighting On
Blinking Blinking
010823
Nylon cutting head (optional accessory for a
product that comes with a cutter blade)
NOTICE:
Do not attempt to bump feed the head while the
•
tool is operating at a high RPM. Bump feeding at a
high RPM may cause damage to the nylon cutting
head.
The bump feed will not operate properly if the
•
head is not rotating.
1
010770
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating at a
low RPM. As the nylon cord is feeding out it will
automatically be cut to the proper length by the cutters
on the guard extension.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance."
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overload protector is shutting
- off the power - the motor was
locked.
Overheat protector is shutting
-
off the power - overheating.
Electric or electronic
malfunction
1. Most effective
cutting area
Action to be taken
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Release the switch trigger and remove the
cause of the motor lock or overload. If the
cutting tool is locked by entangling weeds or
the like, always remove the battery cartridge
before clearing it.
Rest the equipment for a while.
Ask your local authorized service center for
repairs.
Battery remaining capacity indicator (only for
models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light
for approx. three seconds.
11
1. Indicator lamps
2. CHECK button