Facp Programming Menus - Fire-Lite ECC-50 Instruction Manual

Programmed Activation by FACP
cause Message 2 to be generated over speaker circuit 3. If the second addressable device (address
20 in the example below) is also activated, Message 1 will now be transmitted over speaker circuit
3 since Message 1 has a higher priority then Message 2.
Addressable Pull Station
(address 12)
Addressable Pull Station
(address 20)

FACP Programming Menus

To Program one of fourteen messages to a speaker zone, press the ENTER key at the FACP. The
following screen will be displayed:
Access Programming Mode by pressing the 2 key. The following screen will be displayed:
Entering the Master level password (default 00000) will cause the following screen to appear:
Emergency Command Center Manual — P/N LS10001-000FL-E:D 9/3/2014
programmed to Zone 7 and
Message 2
(2nd highest priority of the three)
programmed to
Zone 5 and
Message 1
(highest priority of the three )
1=READ STATUS MODE
2=PROGRAMMING MODE
3=MANUAL DIAL MODE
PROGRAMMING
ENTER PASSWORD
QQQQQ
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
activate
Zone 35
activate
Zone 35
Programming
Speaker Circuit 3
79