Acs Mode Wiring - Fire-Lite ECC-50 Instruction Manual

Output Circuits

ACS Mode Wiring

When communication is wired over the ACS annunciator link, a monitor module must be used to
monitor mass notification events. Wire the monitor module to the ECC at TB1 MNS Active Relay
in addition to the Data Bus wiring shown above. Refer to the FACP manual for information on type
IDs.
Emergency Command Center Manual — P/N LS10001-000FL-E:D 9/3/2014
monitor
module
TB1 MNS Active Relay
Figure 2.21 Monitor Module Wiring for ACS Communication
SLC
Installation
41