2: General/Nac Options; General Options - Fire-Lite ECC-50 Instruction Manual

Main Menu - User Programming
Log Out When all programming has been successfully completed, the user must log out to allow
the system to reboot and apply the programming changes.
3.1.2 General/NAC Options

General Options

Unit Operation Select whether the ECC will function for Fire Evacuation, Mass Notification, or
a Combination of both.
Event Priority When Combo or Mass Notification is selected for Unit Operation, select whether
Mass Notification events or Fire Evacuation events will take priority in the system. If Mass Notifi-
cation is selected as the Unit Operation with the Event Priority set to Fire Evacuation, the ECC will
be a mass notification only system but will allow the FACP to override it if a fire alarm sounds. If
Mass Notification is selected as the Unit Operation with the Event Priority also set to Mass Notifi-
cation, the ECC will not have any fire evacuation capabilities and will report mass notification
events to the FACP. In this configuration, FACP outputs can be turned off for mass notification
events if desired.
FACP Data Bus Control If an FACP will directly communicate with the ECC, select which
communication protocol will be used, ACS-Bus or ANN-Bus.
FACP Data Bus Address This field has no effect on programming and is used for informa-
tional purposes only. When using the FACP ACS-bus protocol, address 01 must be enabled in the
FACP programming. When using the ANN-Bus protocol, the FACP will automatically detect the
audio system connection during annunciator auto-configuration. No ANN-Bus address selection is
necessary at the FACP. Enter the ECC's address (1-8) here. If FACP control of the ECC is not
selected, enter 0.
24 Hour Resound As enabled (default), the 24 Hour Resound feature causes the piezo on the
ECC to sound a reminder 'beep' for alarms and troubles after the panel has been silenced.
Canadian Configuration Selecting enable will configure the panel to comply with Canadian
requirements. See Appendix C for more information.
Class A / Style Z Select enable if all circuits on the ECC will operate in Class A (Style Z) or dis-
abled if all circuits will operate in Class B (Style Y).
Canadian Isolator Modules If audio isolator modules are required in the system, select
enabled. Refer to "Audio Room Isolator Modules" on page 99 for more information.
Emergency Command Center Manual — P/N LS10001-000FL-E:D 9/3/2014
Figure 3.3 General Options
Programming
61