Typical Facp Connection To 411 - Fire-Lite 411 Manual

Input Channels

Typical FACP Connection to 411

FIGURE 2-2:
+
Each input channel monitors a normally open device and may be programmed as follows:
• fire alarm
• host control panel trouble
• fire supervisory
• AC Loss
Programming the input channel automatically programs the transmitted event code, however, the event code can be
changed since it is fully programmable. Event code transmissions can be tailored to the specific application and
requirements of the Central Station.
AC Loss Reporting: Any channel programmed for AC Loss, will transmit a specific AC loss signal only if the assigned
Normally Open contact provides this function. Some panels provide an option that will automatically delay the trig-
ger of their system trouble relays upon loss of AC. If this is provided by the host panel, program no additional delay
in the 411. Be certain to verify the method employed by the host panel to be monitored.
The factory default programming for each channel is as follows:
Channel 1 - fire alarm
Channel 2 - host control panel trouble
Channel 3 - fire supervisory
16
24 VDC nonresettable power
Supervisory
Relay
Alarm Relay
Trouble
Relay
-
Typical FACP MS-9200
411 Communicator
TB2
Channel 1
Channel 2
Channel 3
TB1
J4
J4 Not Installed
2.2K EOLS
P/N 27070
Document #50921 Rev. E 12/09/2008
J1
J2
U10
U8
R41
PH2
411
P/N 50921:E
PH1