Troubleshooting; Specifications - JVC FR-DS100 Instructions Manual

Worldspace digital receiver
Table of Contents

Advertisement

Troubleshooting

WorldSpace transmissions are not received.
• Check that the WS antenna is properly connected. If
using the extension cable, make sure that all connec-
tions are correct and secure. Refer to page 5.
• Check that the WS antenna is positioned to receive
satellite transmissions. Refer to page 9.
• Check that there are no obstructions blocking the path
between the antenna and the satellite.
In the WS band, TUNER/SELECT is turned, but no
broadcast is received.
• Make sure that the LEARN function has been performed
to establish the broadcaster frequency available in your
area. Even if the LEARN function was performed, but the
antenna wasn't correctly oriented, no broadcaster
frequencies will be stored in memory. Refer to page 9.
"BC GONE" appears in the display when you try to
access a specific broadcaster.
• The broadcaster at that location has stopped broadcast-
ing with the WorldSpace network.
The power cannot be turned on.
• Check that the power cable is firmly inserted into the AC
IN jack on the back of the unit and also plugged into an
AC outlet.
Though unlikely to occur, the unit "freezes up" or
becomes unoperable during use.
• When using the AC power cord, unplug the power cord
from the unit or from the wall outlet, then plug it again
to restart the unit.
• When using batteries, remove the batteries, then load
them again.
• When using batteries and the power cord is connected,
unplug the power cord from the unit, then plug it in
again and restart the unit.
There is no sound from the speakers.
• Check that headphones are not plugged in.
• Check that the volume is at an audible level.
• Check that the broadcaster you have selected is not
encrypted (CODED lights in the display).
Radio reception is noisy.
Adjust the antenna appropriate for the band you are
receiving to improve reception. Refer to page 11.
Design and specifications are subject to change
without notice.
20

Specifications

WorldSpace
Transmitting frequencies : 1453.384 MHz – 1490.644 MHz
(L-Band 460 kHz step)
Broadcast system
: WorldSpace
Digital modulation system
: QPSK–TDM
Audio coding system : MPEG 1 / 2 / 2.5 Layer III
Encryption scheme
: ES1, ES2
Number of presets
: 20
Password memory
: 4
Antenna section
Polarization
: Left hand circular polarization
(LHCP)
Right hand circular polarization
(RHCP)
Half power width
: > 60
Power consumption : 60 mW
Total gain
: 36.8
(Element gain: > 6 dBi)
Reception system
: Double super heterodyne system
Minimum input sensitivity : – 85 dBm
Maximum input sensitivity : – 55 dBm
Tuner section
• FM
Frequency range
: 87.5 MHz – 108.0 MHz
Frequency step
: 100 kHz
50 kHz
Number of presets
: 20
• MW
Frequency range
(Saudi Arabian model) : 530 kHz – 1600 kHz (10 kHz step)
531 kHz – 1602 kHz (9 kHz step)
(Except Saudi Arabian model)
: 530 kHz – 1710 kHz (10 kHz step)
531 kHz – 1710 kHz (9 kHz step)
Number of presets
: 20
• SW
Frequency range
: 5.75 MHz – 17.95 MHz
Number of presets
: 20
General
Speaker
: 8 cm (3-15/16") x 2
Power output
: Max. 6.8 W (AC 230 V)
(3.4 W + 3.4 W) at 4
Input jack
: WS antenna jack (F-type plug)
Output jack
: Headphones (MAX 20 mW/
32 )
: EXTERNAL (WS BAND)
: LINE OUT (Analog audio out)
Power supply
: AC 110/127/230 50/60 Hz
DC 9 V ("R20/D (13F)" cell x 6)
Power consumption : 12 W (with
1.6 W (with
ON) button STANDBY)
Dimensions
: 450 (W) mm x 158 (H) mm x 250 (D) mm
(17
Mass
: Approx. 4.6 kg (10 lb. 2 oz.)
with batteries
Approx. 4.0 kg (8 lb. 13 oz.)
without batteries
Accessories provided : WS antenna x 1
AC power cord x 1
8 m extension cable x 1
ID Number seals x 4
AC plug adapter x 1
System
2 dB
(STANDBY/
ON) button ON)
(STANDBY/
11
1
13
/
(W) x 6
/
(H) x 9
/
(D) in.)
16
4
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fr-ds100u

Table of Contents