Regarding Encrypted Broadcaster Signals; Displaying The Unit Id Number; Recording A Broadcast From The Radio Or Ws Band - JVC FR-DS100 Instructions Manual

Regarding encrypted broadcaster
signals
Some broadcasters are available by subscription
only, or may not be available in certain areas, and
the signals from these broadcasters are protected by
the WorldSpace Encryption Schemes 1 and 2 (ES1
and ES2). When you try to receive these
broadcasters, the broadcast is scrambled and the
CODED indicator lights in the display. If a
broadcaster carries a service you are interested in,
the steps below describe the process necessary to
decode the broadcast.
1
Contact a WorldSpace center or an authorized
WorldSpace service provider regarding
broadcaster services and rates in your region.
Refer to page 21 for a list of WorldSpace centers
worldwide.
2
Fill out the application form. At this time, the ID
number of the unit is necessary. An ID number
number sheet with 3 stickers is included with
this unit. The ID number can also be found on
the rear panel of this unit.
On the receipt of the application and any
necessary fees, you will receive a password
corresponding to the ID number of your unit. The
password may be as long as 22 digits in the
following format: A12345-B67890...E12
3
Enter the password.
1. Press and hold the PTY and MULTI/LANG
buttons for three seconds until "PWA_"
appears in the display.
PTY MULTI/LANG
=
+
2. Turn the TUNING/SELECT dial to select the first
number in the "A" password from 0-9 and then
press the MEMORY button. Repeat this process
for each number in the "A" sequence of the
password.
=
TUNING/SELECT
3. Continue the same process until the password
has been completely entered. The unit checks if
the password is correct. If the password was
entered correctly, "COMPLETE" appears in the
display. If the password was entered
incorrectly or is invalid, "PW AGAIN" appears
in the display, and the password must be
entered again from the beginning.
16
WS
WS
=
Notes:
• If you make a mistake while entering the password, press
the MEMORY/CANCEL button when the cursor is not
selecting a number to move the cursor back to the
previous number. Continue this procedure until the
cursor has moved back to the incorrectly entered
number. Numbers that you had entered after that number
must be reentered.
• If you wish to reenter the password from the beginning,
press the WS button and the password is erased and the
mode is exited. Repeat the procedure on this page from
step 3 to enter the password in again.
• If "COMPLETE" appears in the display, but you are still
unable to listen to the broadcaster, contact your nearest
WorldSpace center.
• When the password is entered, sound may be intermit-
tent.
• Up to 4 passwords can be stored in memory. Be sure to
keep your passwords in a safe location where they can be
easily found in case they are somehow erased from
memory.

Displaying the unit ID number

Press the PTY button, MULTI/LANG button and
LEARN button at the same time for 3 seconds. "ID"
appears in the display, followed by the first 8
numbers of the serial number, and then the last 8
numbers of the serial number. This pattern repeats
three times and then returns to the previous display.
Pressing any button ends this operation.
Recording a broadcast from the radio
or WS band
This unit is supplied with stereo output jacks that
allow you to make recordings of the programs you
receive. You can also output the audio signal to an
amplifier or similar component with line inputs.
AC IN
VOLTAGE
SELECTOR
230V
127V
110V
SEE BOTTOM
R L
LINE OUT
LINE OUT
MEMORY
/ CANCEL
To make connections, use a stereo cable to connect
the output jacks on the FR-DS100 to the input jacks
on the other component. Be sure to match the colors
of the cable plugs with the color of the jacks; red
with red, and white with white.
ANTENNA
4 6 5
EXTERNAL 1 3 2
1.5Vx6
WARNING
• DO NOT PUT BATTERY IN BACKWARDS, MIX WITH
USED OR OTHER BATTERY TYPES-MAY EXPLODE
OR LEAK AND CAUSE PERSONAL INJURY.
• REMOVE THE BATTERIES ("D" SIZE, R20) WHEN
USING THE AC POWER.
• SEE INSTRUCTION MANUAL.