Connection Using A Lan Cable; Connection Example; Specifications Of Pc For Controlling This Projector; Configuring The Network Settings - JVC DLA-SH4KNL Instructions Manual

Setup
Connection Using a LAN
Cable
You can control this projector using a computer by
connecting the projector and computer to the network
(LAN).

Connection Example

Router
(DHCP Server)
WAN LAN1
To Network
Terminal
NOTE:
● Use 100Base-TX (Category 5 and above) LAN cables.
Specifications of PC for
Controlling this Projector
OS Windows XP Professional SP2
Windows XP Home Edition SP2
CPU Pentium3 1 GHz or higher
Memory 256 MB and above
NOTE:
● Make use of Internet Explorer Ver. 6.0.
● Windows is either registered trademark or trademark
of Microsoft Corporation in the United States and/or
other countries.
CAUTION:
● The PC specifications above are reference values for
the application software to run smoothly, and are not
intended to guarantee their operation.
Note that the applications may not run smoothly
depending on the condition of use of the respective
users even when the system requirements are
satisfied.
20
LAN
LAN2 LAN3 LAN4
DVI 1
DVI 2
CONTROL
USB
DVI 3
LAN
STANDBY/ON
OPERATE I/B
LAMP
To LAN
DVI 4
WARNING
RS-232C
Terminal
Configuring the Network
Settings
This sections describes the procedures when the IP
address is automatically assigned by the DHCP server.
1
Check to ensure that this projector is
connected to the DHCP server via a LAN
cable
2
Connect the supplied power cord to the
power input terminal of this projector
2
5
3
Insert plug into the power outlet on the wall
4
Remove the lens cap
5
Turn on the main power of the projector to
set to [I]
● The [STANDBY/ON], [LAMP], and [WARNING]
indicators light up for about 45 seconds, after which
the [STANDBY/ON] indicator turns red.
6
Launch the web browser on the computer
Power Cord
3
(Supplied)