Assigning Ip Address From The Dhcp Server; Using The Mail Delivery Feature; Connection Example (When Dhcp Server Is Used) - JVC DLA-SH4KNL Instructions Manual

Assigning IP Address from the
DHCP Server
The IP address is automatically assigned by the DHCP
server.
1
After connecting, turn on the main power.
● Refer to page 22 on the details of connection.
● Refer to page 23 for procedures to turn on the main
power.
2
Set the DHCP Client setting of this
projector to DHCP .
● The IP Address Setting of this projector is set to
Static IP (the DHCP client function is OFF) by
default. When assigning an IP address from the
DHCP server, access this projector from the
computer to alter the settings. For details on the
setting procedures, refer to "Setting (Changing) the
IP address of this projector". (A Page 25)
NOTE:
● Please consult the network administrator on the IP
address assigned to this projector.
● When DHCP Client is set to DHCP , and if the
projector is started up in a LAN where a DHCP server
does not exist, the projector will start up using the
default IP address instead.
CAUTION:
● Configure the DHCP server such that the same IP
address is assigned to the Mac Address of this
projector by the DHCP server at all times. Connection
may fail if the above setting is not performed.
Connecting this projector and the computer
using a USB cable
You can connect this projector and the controlling
computer using a USB cable.
● You need to install a driver in order to connect the
projector and computer using a USB cable.
NOTE:
● For details on the installation of the USB driver,
please consult your authorized dealer.
Using the Mail Delivery
Feature
This feature enables delivery of mail (error message) to
the preset e-mail address when error occurs inside this
projector unit.
Connection Example (When
DHCP Server is Used)
To Internet Connection
WAN LAN1 LAN2 LAN3 LAN4
DHCP Server
To LAN Terminal
ADSL modem, etc.
ETHER
LAN
DVI 1
DVI 2
CONTROL
USB
DVI 3
LAN
STANDBY/ON
OPERATE I/B
LAMP
DVI 4
WARNING
RS-232C