JVC DLA-SH4KNL Instructions Manual page 79

Item Setting Value
Power ON
OFF
Latest Error —
Signal Status
DVI —
Rate(Hz) —
Pixel H —
Pixel V —
Link —
Temperature
Temp. 1 —
Temp. 2 —
Projector Usage
Reset —
For turning the power ON/OFF.
ON : Turns on the power.
OFF : Turns off the power.
NOTE:
● The following operating modes of the projector are displayed to the
right of the OFF button.
STANDBY
PROJECTION
FAN ENABLE
LAMP ENABLE
DEVICE ENABLE
COOLING
EMERGENCY
EMERGENCY COOLING : Error Occurred (Cooling performed)
● When in the standby mode, clicking the ON button each time
switches the mode in the sequence of STANDBY DEVICE
ENABLE LAMP ENABLE FAN ENABLE PROJECTION.
● Clicking the OFF button when the power is on switches the projector
to the cooling mode. The power of the projector cannot be turned on
during the cooling process (180 seconds).
Displays the latest error number. Refer to Latest Error for information
on the error number and details. (A Page 48)
Displays information on the input signals.
DVI : Displays the input terminal number.
Rate(Hz) : Displays the vertical frequency.
Pixel H : Displays the horizontal resolution.
Pixel V : Displays the vertical resolution.
Link : Displays the link status of the DVI terminal.
Displays the interior temperature of the projector.
Temp. 1 : External Temperature
Temp. 2 : Internal Temperature
Displays the time interval during which the lamp is in use.
CAUTION:
● Do not click on Reset unless the lamp is replaced.
Description
: Standby (OFF)
: Lamp Illuminated (ON)
: FAN Enable (OFF ON)
: LAMP Enable (OFF ON)
: Elemental Device Enable (OFF ON)
: Cooling (OFF)
: Error Occurred (Cooling not performed)