Panasonic KX-TD816CE Installation Manual page 11

Pay Tone Card (KX-TD189) Installation
(2) Installing to the Optional 4-CO Line Unit
Programming References
Feature References
The following procedures must be done before installing the 4-CO
Line Unit (KX-TD180) to the main unit.
1. Loosen five screws located on the rear of the 4-CO Line Unit.
2. Remove the back plate and take out the P-board.
3. Attach the Pay Tone Card to the P-board, fitting the connectors.
4. Put the P-board back into the cabinet and fix the rear plate with
the five screws.
5. If you do not cut the wire of the J200 in Pay Tone Card, the
detected mode is 16 KHz. If you cut the wire of the J200 in pay-
tone card (Open Mode), the detected mode is 12 KHz.
P-board
Note To install the 4-CO Line Unit to the main unit, refer to Section 2.4.4
"Installing Expansion Unit (KX-TD170 / KX-TD180)" in the
Installation Manual.
Section 4, System Programming,
[423] Pay-Tone Assignment
Section 3, Features,
Display, Call Information (in this manual)
HOTEL APPLICATION (in this manual)
back plate
J200
J200
Cut here
11